Maytag Bravos Dryer Won't Start Just Clicks

Maytag Bravos Dryer Won't Start Just Clicks. My maytag dryer lights up when power is pushed. Maytag dryer won't start from.

Maytag washer spin light flashing from germdisruptor.com

On most dryers, when the dryer belt breaks, the motor will still run, but the drum won’t turn. I replaced the thermal fuse and now it works great. Remove the top panel to get access to the start button.

The Start Switch Could Be Faulty;

You can ohm it for continuity with a multimeter, make sure your dryer is unplugged first! Maytag bravos dryer won't start just clicks there may be several reasons why your dryer will not start or operate. I replaced the thermal fuse and now it works great.

The Thermal Fuse Helps To Prevent A Dryer Fire By Shutting Off Power To The Dryer If It Overheats.

It clicks but won’t start. Ok so, this means that your thermal fuse has likely gone bad and will need to be replaced. I have a gas kenmord elite dryer that has power to the board.

An Extension Cord, A Tripped Breaker, Or A Faulty Thermal Fuse, Outlet, Or Power Cord.

As a safety precaution, a dryer won’t start if the door isn’t completely shut and latched. Press and hold the power/start button for 5 seconds. The indicator lights will go off.

Defective Maytag Dryer Thermal Fuse.

You can test the breaker by turning the breaker off and then back on. Hold the button down for three seconds. My maytag dryer lights up when power is pushed.

If Your Dryer Just Clicks And Will Not Start, A Blown Thermal Fuse Is Often The Problem.

The fuse is hidden in back of t. The dryer was working fine, i opened the door and it would not restart. Make sure both fuses are intact and tight, or that either circuit breaker has not tripped.

Leave a Comment