How To Turn On Hot Water Heater Pilot Light

How To Turn On Hot Water Heater Pilot Light. Turn off the gas control valve. As you watch the burner, move the gas dial to where it says ‘pilot’.

How To Turn On Pilot Light On Hot Water Heater from globaltorial.blogspot.com

Continue holding the pilot button down for 60 seconds to ensure the flame stays lit. Remove your foot from the gas pedal. Next, i’m going to continue to press and hold the dial in the pilot setting and also start to press the igniter button below it.

Steps To Relight The Pilot Light.

7 reasons why the water. To relight the pilot, turn the knob to the pilot position. On a modern rheem gas water heater, it is very easy to light the pilot light.

Open The Door Or Cover That Provides Access To The Pilot Light.

Above the temperature dial, look for the “on,” “off,” and “pilot” buttons. The knob should be labeled in a clear. There will be a red or black button marked “ignition,” press it for about 60 seconds.

On Most Hot Water Heaters This Is A Small Flame Or Spark Symbol.

Steps for relighting the gas water heater pilot light. How to light a water heater with electronic pilot: Turn off the gas control valve.

The Knob Should Be Clearly Labelled.

Different igniting systems may vary slightly. This can be seen at the bottom of the heater. First of all, we need to make sure whether the pilot light is actually out.

If Your Hot Water Heater Is A Manual, Grab A Long Lighter.

Turn it to the “off” setting. Keep holding down the pilot knob or button for at least a. Turn the control valve to “on”.

Leave a Comment